To Next Page

To Previous Page

3-16 ApexPro™ 2001989-351A

Installation and configuration

2. At the PC, use a communication program such as HyperTerminal to set up the

ComPort connection.

3. Press Enter to get the @> Enter Service Password: prompt.

4. Type password, mms_aps (case-sensitive).

5. Press Enter.

6. At the @> prompt type ssf.

The command is “ssf x” where x identifies which antenna field(s) to enable.

Enter the “ssf x” command as listed below to configure the desired antenna

field(s).

7. Exit the communication program, then disconnect serial cable and PC, or

continue with step 6 in Setup the receiver on page 3-17.

Port: Com1 (comm port on the PC)

Speed: Baud 19200

Parity: No

Stop Bit: 1

Data Bits: 8

Flow Control: Xon Xoff

X Field D Field C Field B Field A

1 Disabled Disabled Disabled Enabled

2 Disabled Disabled Enabled Disabled

3 Disabled Disabled Enabled Enabled

4 Disabled Enabled Disabled Disabled

5 Disabled Enabled Disabled Enabled

6 Disabled Enabled Enabled Disabled

7 Disabled Enabled Enabled Enabled

8 Enabled Disabled Disabled Disabled

9 Enabled Disabled Disabled Enabled

10 Enabled Disabled Enabled Disabled

11 Enabled Disabled Enabled Enabled

12 Enabled Enabled Disabled Disabled

13 Enabled Enabled Disabled Enabled

14 Enabled Enabled Enabled Disabled

15 Enabled Enabled Enabled Enabled

GE ApexPro Technical Manual

Other manuals for GE ApexPro