GE Bently Nevada 1900/27 - Page 51

Section 7 - Appendix C - 1900/27 Monitor Configuration Form
45
1900/27 Vibration Monitor Configuration Form Monitor
Configuration:
Point Plant Name : ___________________________________________
Location Unit Name : ___________________________________________
Machine Name : ___________________________________________
Machine Type : ___________________________________________
Transducer Orientation: Radial | Axial Angle: ________________
Orientation Zero Degree Reference: ____________________________
Setpoint Alert Setpoint : ___________ in/s | mm/s
Levels Danger Setpoint : ___________ in/s | mm/s
Jumper W4 - Trendmaster
®
2000 Bypass Mode : IN | OUT
Settings W5 - Danger Relay Normally Energized/ De-energized Mode : IN | OUT
W6 - Alert Relay Normally Energized/ De-energized Mode : IN | OUT
W7 - Danger Relay Latching/Nonlatching Mode : IN | OUT
W8 - Alert Relay Latching/Nonlatching Mode : IN | OUT
Configuration Relay Time Delay : 3 s | 5 s | 10 s | 15 s
Switch Alert Relay Drive : Alert | Alert OR NOT OK | NOT OK | Danger
Settings Velocity Units (peak) : English - in/s | Metric - mm/s
(This page may be copied)