GE CL 5

1-6 Issue 01, 04/05 CL 5
Instrument Options
 A-Scan Upgrade Option
 Data Recorder Upgrade Option
 Velocity Measurement Option
1.4 Whats in this Manual
The CL 5 Operating Manual is divided into ten
chapters. All chapters except 4 and 5 apply to all
instruments. The last two sections of Chapter 4 apply
only to instruments equipped with the A-Scan or
Velocity measurement options. Chapter 5 applies only
to instruments equipped with the Data Recorder option.
Note that any CL 5 can be retrofitted to incorporate
these options. Following is a summary of Chapters 1
through 10:
Chapter 1General Introduction
 Supplying Power to the instrument
 Powering on and off the instrument
 Overview of instrument features
 Explanation of the operating manual contents
Chapter 2Understanding the Keypad, Menu
System, and Displays
 Operations performed by each key
 Navigating the display screens
 Overview of menu functions
 Explanation of display features (base model, data
recorder, and A-Scan equipped instruments)
 Definition of icons
Chapter 3Setting Up the CL 5
 Install a probe and configure the instrument by
loading a setup file
 Set up the instrument display appearance (for base
model and A-Scan equipped instruments) and make
other configuration settings
General Information Whats in the Manual
1-6 Issue 01, 04/05 CL 5
Instrument Options
 A-Scan Upgrade Option
 Data Recorder Upgrade Option
 Velocity Measurement Option
1.4 Whats in this Manual
The CL 5 Operating Manual is divided into ten
chapters. All chapters except 4 and 5 apply to all
instruments. The last two sections of Chapter 4 apply
only to instruments equipped with the A-Scan or
Velocity measurement options. Chapter 5 applies only
to instruments equipped with the Data Recorder option.
Note that any CL 5 can be retrofitted to incorporate
these options. Following is a summary of Chapters 1
through 10:
Chapter 1General Introduction
 Supplying Power to the instrument
 Powering on and off the instrument
 Overview of instrument features
 Explanation of the operating manual contents
Chapter 2Understanding the Keypad, Menu
System, and Displays
 Operations performed by each key
 Navigating the display screens
 Overview of menu functions
 Explanation of display features (base model, data
recorder, and A-Scan equipped instruments)
 Definition of icons
Chapter 3Setting Up the CL 5
 Install a probe and configure the instrument by
loading a setup file
 Set up the instrument display appearance (for base
model and A-Scan equipped instruments) and make
other configuration settings
General Information Whats in the Manual