Need help?Do you have a question about the GE CheckPoint and is the answer not in the manual?
General| Type | Ultrasonic flow meter |
|---|---|
| Fluid Types | Water, chemicals |
| Power | 100-240 VAC, 50/60 Hz |
| Display | LCD |
| Outputs | 4-20 mA, pulse |
| Data Logging | Yes |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Operating Temperature | -4°F to 140°F (-20°C to 60°C) |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Pipe Size Range | 0.5 inch to 48 inch (12.7 mm to 1219 mm) |
| Temperature Range | -40°C to 100°C (-40°F to 212°F) |
| Measurement Range | 0.01 to 9 m/s (0.03 to 30 ft/s) |
Install the mounting bracket and attach the sensor, ensuring adequate clearance for optional kits.
Secure the sensor to the mounting bracket, allowing clearance for optional kits.
Turn off power and remove the fluidics cover as the first step in pump head replacement.
Disconnect the tubing from barbs and loosen screws to remove the pump head.
Align the new pump head on the post and tighten the screws to secure it.
Loosen and remove the lamp connector from the bulkhead.
Loosen the brass-colored nut and carefully pull out the lamp.
Insert the new lamp, tighten the nut, and secure the power connector.
To Next Page
