EasyManua.ls Logo

GE DBL333 - Before You Call For Service

GE DBL333
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Beforeyou call forservice...
Troubleshooting -tips
Save time and money/.Review the charts on the following
pages first and you may not need to call for service.
Problem Possible Causes What ToDo
Dryer doesn't start Dryer is unplugged o Make sure tile &yer plug is pushed completely into
the outlet.
Fuse is bloval/circuit breaker is * Check the house filse/( ir(:uit breaker box and
tripped repla(e fllse or reset breaker. NOTE:Most ele( tri(
d_yers use two filses/breakers.
Thermal limiter tripped o Call authorized self'it e person fin repla(ement.
Dryer doesn'theat Fuse is blown/circuit breaker is * Check tile house filse/circuit breaker box and
tripped,the dryer maytumble replace fllse or reset breaker.
but not heat
Gas service is off o Make sure gas shutoffat &yer and main shutoffare
flflly open.
There are 2 house fuses in the - Replace fiase.
dryer circuit. If 1 of the 2 fuses
is blown, the drum may turn but
the heater will not operate
Gas supplyvalve is not open * Check to make sure supply valve is open. See
(gas models) InstallationInstructionstbr pro(e&lre.
Dryer does not have enough air * See Installation Instructions
supply to support the bunmr
flame (gas models)
LP gas supply tank isempty * Refill or replace tank. Duet should heat when utility
or there has been a utility servi( e is restored.
interruption of natural gas
(gas models)
Dryer shakes or makes Some shaking/noise is normal. * M_we duer to an even floor space, or a({iust
noise Dryer may be sitting unevenly leveling legs as net essaU until even.
Greasy spots on clothes hnproper use of fabric softener * Follow directions on ihbri( softener package.
Drying dlrtyitems with clean ones * Use your d_yer to d_y only (lean items. Dirty items can
stain (lean items and tile &yer.
Clothes were not completely clean * Sometimes stains which cannot be seen when (lie
(lothes are wet appoaratier &)_ng. Use proper
washing pro( e&lres beii_re &}dng.
Lint on clothes Lint filter is full * Clean lint screen betore each load.
Improper sorting * Sort lint pro&lcers (like chenille) from lint collectors
(like corduroy).
Static electricity can attract lh_t * See suggestions in this section under STATIC.
Overloading * Separate large loads into smaller ones.
Paper, tissue, etc. left in pockets * Empty all pockets betore laundering clothes.
20

Other manuals for GE DBL333

Related product manuals