35
Removing the door switch:
1. Disconnect the dryer from electrical supply, open
the door and remove the top.
2. Disconnect the wires from the door switch.
3. Squeeze the release tabs on the ends of the switch
and push it out the front.
Removing the front panel:
1. Disconnect the dryer from electrical supply, re-
move the console and front access panel.
2. Remove the (2) screws, one on each side, at the
bottom holding the front panel to the bodysides.
3. Remove the (2) screws, one on each side about 8
inches down from the top, that secure the front
panel to the bodysides.
4. Pull out on the bottom of the front panel to release
the spring load tabs.
5. Lift up on the front panel to release the (2) tabs at the
top, one on each end, and swing the panel out.
6. Disconnect the wiring from the drum light, the door
switch, the ground wire, and the wiring harness
from the sensor bars.
To Next Page
