48 DVSR xU User Manual
4. Go to the Alarm Schedule and select the day of the week for which you want to set the response
time schedule. Go to Period 1 and enter the time period for the response. You can set up to four
time periods for each day of the week. Time is entered in the 24-hour format.
Note: The four daily time periods cannotoverlap.
5. Go to the notification options and press Enter or left-click the mouse to enable () or disable how
you want the DVSR xU to respond to a video loss tamper alarm. See Table 12.
Table 12: Notification options on how to respond to a video loss tamper alarm
Full Screen On Alarm channel will be displayed full
Buzzer An audible alarm sounds
TCP Alarm information is sent to the remote IP (see Network section.)
Email Alarm information is sent to an Email address (see Network section.)
Alarm Out When enabled, the Alarm Out is activated. Up to four alarm outputs can be
enabled.
6. Select OK to confirm changes and return to the Camera menu.
To copy a camera’s settings to another camera
1.
In the Camera menu go to the Camera list box and select the camera whose options you want to
copy.
2. Go to Copy to Camera and select the camera to which you want to copy the settings.
3. Go to Copy and press Enter or left-click the mouse. All settings will be copied to the selected
camera.
Note: Motion alarm zones cannot be copied.
To Next Page
