GE enFlow IV - Storing the Enflow IV Fluid;Blood Warming System Components

4400-0024 enFlow Operator’s Manual EN Rev. T 05/12 Page 16 of 26
5. Confirm operation. Connect the Warmer to a Controller. Insert a Disposable Cartridge into the
Warmer and close the covers. Turn the Controller to the ON position, and allow the start up
procedure to run until complete.
Cleaning the Controller
1. Use only approved cleaning solutions.
2. Moisten a clean cloth with the cleaning solution; do not spray or pour cleaning solutions
directly on to the Controller.
3. Wipe the surface of the Controller, taking care not to leave excess residual cleaner on the
Controller. If fluid ingress is detected, set the Controller aside for an extended period of time
to allow it to dry.
Storing the enFlow IV Fluid/Blood Warming System Components
The Warmer and Controller should be stored in a clean, dust free environment. (See Appendix A)