GE GBS22**P - Freezer Drawer and Slides Removal and Replacement

Removal
and Replacement
1.
Open the freezer
drawer
until it
stops.
2. The bottom
basket
rests
on
a
frame
inside
the
lreezer
drawer.
To remove
it, liftthe
basket
ftom
the
back and
slide it toward
the
freezer
compartment.
3.
Remove
the single Phillips-head
screw on
each side
of
the
rail.
Note: Do not
remove
the
hex-head
screws from
the
rail
assemblies.
The
tabs on the side of
the drawer
rails
fit into
the front
slots of the
guide
rails.
Lift
the
drawer
by the handle to
separate the
drawer
rails
ftom
the
guide
rails.
Set
the
drawer
on a
non-scratching
surface.
Remove
the middle
basket, top
basket, ice
tray
shelf, dnd
ice
bin.
The
center rail
assembly is held
in
place
by
a
molded
channel in
the
treezer
ceiling and
notches in
the metal
support rails.
Remove
the
center rail assembly
by
pressing
down
on the
metal
support
rails while
rotating
the
bottom
edge of
the
center rail assembly.
To remove
the metal support rails,
press
the
tabs
on the
plastic
support housing.
Remove the
3
Phillips
screws that
hold
the
plastic
support housing
in
place.
5.
6.
7.
8.
4.
o
IXt
t{OTnmow
ter headccnua