30 /
Copyright General Electric 2011
9/23/2012
Error Code and Service Modes
STC Representative or Tech can direct a
consumer into Error Code Mode.
Errors:
• Minimum Water Temp (120 F) not met in last 3 of 5 cycles
• Communication Error
• Thermistor Error Control interprets 40 degrees - 26.5K as Open
200 degrees - .9K as Shorted
• Turbidity Sensor Error
Service Mode: must be entered while in
Error Code Mode. This Mode is meant for Technicians
Only. Load Control is achieved here
To Next Page
Loading...
