To Next PageTo Next PageWhy is there cloudiness on glassware in my GE GDT530?
Cloudiness on glassware can be due to a combination of soft water and using too much detergent, which causes etching and is permanent. Use less detergent if you have soft water and wash glassware in the shortest cycle that will get it clean. Another cause is water temperature entering the dishwasher exceeding 150°F (66°C); lower the water heater temperature.
How to prevent cloudiness on glassware in my GE Dishwasher?
Cloudiness can result from a combination of soft water and too much detergent, leading to etching. To prevent this, use less detergent if you have soft water and wash glassware in the shortest cycle possible. Also, the water temperature entering the dishwasher exceeding 150°F (66°C) could be etching, so lower the water heater temperature.
Why won't my GE Dishwasher pump water out of the tub?
The drain might be clogged. If you have an air gap, clean it. If the dishwasher drains into a disposer, run disposer clear. Check to see if your kitchen sink is draining well. If not, you may need a plumber.
Why is my GE GDT530 Dishwasher control panel responding to inputs but the dishwasher never filled with water?
Make sure the door is firmly closed. Ensure the water valve (usually located under the sink) is turned on. The flood float may be stuck. Remove the Ultra-Fine Filter assembly and lightly tap the piece under the ultra fine filter assembly that looks like a dome. Replace the filter.
How to turn off beeping at the end of the cycle on my GE GDT530 Dishwasher?
To turn off the double beep indicator (or re-activate it if it was previously turned off), press the Heated Dry pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been turned on or off.
Why are there suds in my GE GDT530 Dishwasher tub?
Suds in the tub are usually caused by using the wrong detergent or spilling rinse agent. Use only high-quality automatic dishwasher detergents like Cascade® Platinum™ ActionPacs™ or Finish® Quantum® Automatic Dishwashing Detergent. If rinse agent was spilled, wipe it up immediately. To remove suds, open the dishwasher and let them dissipate. Pump out water by pressing Start and close the door. Wait 30 seconds. Open the door, press and hold Start for 3 seconds, and close the door. Repeat if necessary.
Why is detergent left in the dispenser cup of my GE Dishwasher?
Detergent left in the dispenser cup means that dishes are blocking the detergent cup. Reposition the dishes so the water from the lower spray arm can flush the detergent cup. Reposition dishware that may be keeping the dispenser cup door from opening; see the Loading section.
Why do the control panel lights go off when setting controls on my GE Dishwasher?
Each pad must be touched within 30 seconds of the others. To relight, touch any pad again or open the door and unlock (top control).
Is steam from my GE GDT530 normal?
Yes, it is normal. Warm, moist air comes through the vent during drying and when water is being pumped out, which is necessary for drying.
Why doesn't the sanitized light illuminate at the end of the cycle on my GE Dishwasher?
The door was opened and the cycle was interrupted during the final rinse. Do not interrupt the cycle by opening the door during the wash cycle. Also, the incoming water temperature was too low. Raise the water heater temperature to between 120°F and 150°F.
General| Brand | GE |
|---|---|
| Model | GDT530 Series |
| Category | Dishwasher |
| Language | English |
