To Next PageTo Next PageWhat noises are normal for a GE Dishwasher?
Normal operating sounds include beeping at the end of the cycle (on some models), the detergent cup opening, water entering the dishwasher, the motor stopping and starting, spray arms starting and stopping, and drain pump sounds during pump out. If dishes are rattling, make sure they are properly loaded. If silverware is rattling against the door, place tall utensils in the upper rack.
How to get rid of suds in my GE GDT530 Dishwasher?
If you see suds in the tub of your GE Dishwasher, it's likely due to using the wrong detergent. Use only automatic dishwasher detergents to avoid sudsing; Finish® Quantum® Automatic Dishwashing Detergent is approved for use in all GE Appliances dishwashers. To remove suds, open the dishwasher and let them dissipate. Pump out the water by pressing Start and closing the door, wait 30 seconds, then open the door, press and hold Start for 3 seconds, and close the door. Repeat if necessary. Also, spilled rinse agent can cause suds, so always wipe up spills immediately.
Why do the control panel lights go off on my GE Dishwasher?
If the control panel lights go off while you’re setting controls on your GE Dishwasher, it means the time between touching the selected buttons was too long. Each pad must be touched within 30 seconds of the others. To relight, touch any pad again or open the door and unlock (top control).
What to do if there are suds in the GE GDT530 tub?
If you see suds in your GE Dishwasher tub, it's likely due to using the wrong detergent or spilling rinse agent. Only use automatic dishwasher detergents to prevent sudsing; Finish® Quantum® Automatic Dishwashing Detergent is approved for use in all GE Appliances dishwashers. To remove existing suds, open the dishwasher and let them dissipate. Always wipe up any rinse agent spills immediately.
Why is detergent left in dispenser cups of my GE Dishwasher?
If your GE Dishwasher has detergent left in the dispenser cups, it means dishes are blocking the detergent cup. Reposition the dishes so the water from the lower spray arm can flush the detergent cup.
Why are there suds in my GE GDT530?
If you see suds in your GE Dishwasher tub, it's likely due to using the wrong detergent. Use only automatic dishwasher detergents, such as Finish® Quantum® Automatic Dishwashing Detergent. If suds are present, open the dishwasher and let them dissipate. Pump out the water by pressing Start and closing the door, waiting 30 seconds, then opening the door, pressing and holding Start for 3 seconds, and closing the door. Repeat if necessary. Also, if rinse agent was spilled, always wipe it up immediately.
Why is detergent left in the dispenser cups of my GE Dishwasher?
If detergent is left in the dispenser cups of your GE Dishwasher, it's likely that dishes are blocking the detergent cup. Reposition the dishes so the water from the lower spray arm can flush the detergent cup. Also, reposition any dishware that may be keeping the dispenser cup door from opening.
Why doesn’t the sanitized light illuminate at the end of the cycle on my GE Dishwasher?
If the Sanitized light does not illuminate at the end of the cycle on your GE Dishwasher, it could be because the door was opened and the cycle was interrupted during the final rinse. Avoid interrupting the cycle by opening the door. Additionally, the incoming water temperature may have been too low. Raise the water heater temperature to between 120°F and 150°F.
Why is there steam coming from my GE GDT530?
Steam coming from your GE Dishwasher is normal. Warm, moist air comes through the vent during drying and when water is being pumped out. This is necessary for drying.
How to stop suds in my GE GDT530?
Suds in the tub usually indicate that you're using the wrong detergent or that rinse agent was spilled. Use only high quality automatic dishwasher detergents to avoid sudsing. Cascade® Platinum™ ActionPacs™ or Finish® Quantum® Automatic Dishwashing Detergent have been approved for use in all GE Appliances dishwashers. To remove suds from the tub, open the dishwasher and let suds dissipate. Pump out water by pressing Start and close the door. Wait 30 seconds. Open the door, press and hold Start for 3 seconds, and close the door. Repeat if necessary. Wipe up any rinse agent spills immediately.
General| Brand | GE |
|---|---|
| Model | GDT530 Series |
| Category | Dishwasher |
| Language | English |
