Service Mode Tests
78
(t4) Error Codes:
The control shall display the most recent error in the fault log upon entry
into the display error codes test. If there are no errors in the fault log,
then No Error Code (“000") shall be displayed on the 7-segment display.
The control shall clear the displayed error from the fault log if the Start
button is pressed during the display error codes test.
After clearing the displayed error from the fault log, the appliance shall
display the next most recent error from the fault log.
After clearing all errors from the fault log, the control shall display the
("000“) code on the 7-segment display.
The control shall log the last 8 error codes in the non-volatile memory
stored in a circular list.
To Next Page
Loading...
