GE GFWR4800 - Advanced Wash Features

7
GEAppliances.com
PreWash
Prewash is an extra wash before the
main wash. Use it for heavily soiled
clothes or for clothes with a care
label that recommends prewashing
before washing. Be sure to add liquid
or powder high-efficiency detergent,
or the proper wash additive to the
prewash dispenser.
The PreWash feature will fill the washer
(adding the prewash detergent), tumble
the clothes, drain and spin. Then the
washer will run the selected wash cycle.
NOTE: In some special cycles, the
prewash is selected automatically
as the default. You can modify this
selection at any time.
8
PreSoak (on some models)
For soaking your garments before the
wash cycle begins. This option begins
with a brief tumble and then proceeds
to soak the clothes for a specified
period of time. Once complete, the
cycle will begin automatically.
The PreSoak time is set in ½ hour
increments, with the maximum
presoak set option of 8 hours.
If desired, add high-efficiency detergent
or the proper wash additive to the
prewash dispenser.
9
10
11
12
eWash (Energy Savings Wash)
(on some models)
Use eWash to save energy on specified
wash cycles.
eWash cannot be used with Allergen,
Sanitize, Power Clean and Basket
Clean.
Overnight Dry™
(on some models)
Overnight Dry is available on the
following cycles: Active Wear, Whites,
Normal and Single Item.
Overnight Dry is intended for smaller
loads only. This feature is intended for
use when clothes need to be washed,
dried and ready to wear or finished the
next morning. This feature will tumble
clothes and introduce a constant stream
of air into the machine compartment
upon completion of select wash cycles.
Clothes can be removed at any time by
pressing Pause.
To use the feature, press the Overnight
Dry button and follow the prompts on
the screen.
High wear or delicate articles are not
recommended for this cycle.
The table below describes example
loads that can be used with this
feature:
2-3 athletic uniforms
2 sets of scrubs
2 sets of baby's crib sheets
1 dress shirt, 1 pair of dress pants
3 dress shirts
My Cycle
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin speed
and wash temp settings and hold down the
My Cycle button for 3 seconds. A beep will
sound to indicate the cycle has been saved.
To use your custom cycle, press the
My Cycle button before washing a load.
To change the saved cycle, set the
desired settings and hold down the
My Cycle button for 3 seconds.
NOTE: When using My Cycle, wash
options cannot be modified after the
cycle has been started.
NOTE: If you change wash options with
My Cycle before starting the cycle, the
My Cycle light will turn off and you will
be returned to the base cycle.
On some models, there is a
My Cycle 1 and a My Cycle 2
button which allows you to
save two favorite cycles.