Installation Instructions
ADAPTIVE VIBRATION CONTROL
Your GEwasher is equipped with Adaptive Vibration Control
Technology. Using information about the floor, this system
can reduce vibration and improve spin performance in
some installations by adapting the spin cycle.The DEFAULT
configuration isspecially designed to provide optimal
performance acrossthe widest range of floor types. Follow
the procedure below to enable more specific adaptive
settings.Yourwasher can be returned quickly and easily
to the DEFAULTconfiguration at any time using the same
procedure.
Floor Type Selection
.
Placecontrol in the idle state. (Hake sure no cycles or
options ore selected but that the washers Power is on.)
Pressand hold the Power and Spin buttons at the same
time for 3 seconds.
3. Only the Power,Start and display lightswill be lit in this
mode.
4. Pressingthe Power button in this mode will return the
control to the idle state and the defaults will be restored.
5.
Rotate the selector knob to select the Floor Type, per
the following table.
FO
F1
F2
O0 t"
Default
Concrete Floor
Second Floor,oil surface types
F3 First Floor,Tile Surface
F4 First Floor,Linoleum surface
F5 First Floor,wood surface
.
0
7.
Pressthe Stortbutton to make selection.
ForGERightHeight DesignTM frontload washers with u
Built-In RiserTM models (GFWR4800and GFWR4805)- Exit
the Floor Type selection mode and return to the idle state
after the Stert button ispressed.Theprogramming of
your washers Adaptive Vibration Control isnow complete.
For all other models (GFWS2500, GFWS2505, GFWS2500,
GFWS2505, GHWS3500, GHWS3505, GFWS3700 and
GFWS3705) - proceed to the pedestal selection (steps
7-9).
Rotatethe selector knob to select the Pedestal Type, per
the following table.
PO No Pedestal (Default setting)
P1 Pedestal
8. Pressthe Startbutton to make selection.
9. Exitthe Pedestal Type selection mode and return to the
idlestate after the Start button ispressed.
24
To Next Page
Loading...
