Packaging - Shipping and storage
Packaging - Identification - Storage
GE Information L22- 014EN/05
3/6
06- 2017
Identifying sub- assemblies and their packagin g
Introduction
Each circuit- breaker sub- assembly (poles, operating mechanism, etc.) is
identified by a plate giving its reference numbers.
These numbers are marked on the packaging cases of each sub- assembly.
Example of marking
and identifying
- Manufacturer reference No. = 101 525
- Circuit- breaker identification No. 1
- Pole No. 2
101 525 0010
n
o
SERIJA
Ozn. 01/2
101 525 0010
MANUFACTURER
REFERENCE No.
POLE No.
MARKING OF
PACKAGING CASES
IDENTIFICATION OF
SUB- ASSEMBLIES AND
TOOLING
1
2
0101
CIRCUIT- BREAKER
IDENTIFICATION No.
CASE No.
Place of the plates
Choose and install the components identified by the plate (1).
OUTSIDE PLATE
INSIDE PLATE
101 525 0010
Ozn. 01/2
n
o
SÉRIE
1
To Next Page