How to operate your dishwasher
II
I
STEP 1. Load your dishwasher
with dishes, silverware, pots, pans,
bowls, etc. according to
instructions on
pages
8
and
9.
STEP 2. Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator Dial is
at
OFF
position
before
adding detergent.
(See
pages
6
and 7.)
Use rinse aid agent to help prevent
spotting. Occasionally check to
insure that rinse agent container is
at least half
full.
(See page 6.)
STEP 3. Select drying option.
HEATED
DRYING
NO HEAT
DRYING
HEATED DRYING. Turns the
drying heater on
for
fast drying.
NO HEAT DRYING. Turns the
drying heater off to
save
energy.
Dishes will dry naturally over
a
longer period such as overnight.
If you need your dishes sooner,
open the dishwasher
door
after
the
cycle
is complete to reduce the
natural
drying
time.
STEP 4. WASH HEAT BOOST
Option.
WASH HEAT BOOST.
This
cycle
will
be extended
for
2 I
minutes while the dishwasher
automatically heats the water for
good washing and drying. The
entering water must be at least
120°F.
ENERGY SAVER (NO
HEAT
BOOST). When this option is
selected the entering water must be
at least
140°F.
To test water
temperature, see page 6.
STEP 5. Select the
cycle
and start
the dishwasher.
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher.
(See
Cycle
Selection Hints on next page. )
● For POTSCRUBBER,
NORMAL WASH and
I.IGHT
WASH cycles:
POT- NORMAL LIGHT
SCRUBBER WASH WASH
c.
Slowly turn Cycle Indicator
Dial
to
ON position to start the
cycle. You will hear the motor
start. There is a time delay
between start-up and water fill
so you will not hear any wash
action right away.
To obtain the benefits of a
complete cycle, be careful that
you do not turn the dial any
further than necessary to start
the dishwasher.
● For
RINSF.
& HOLD cycle:
O;F
:N
., WASHING
DRYING
‘s
,@”
1/
.
RI NSE& HOLO
I!ISI
‘:}$::0”,’U.I
a. Be sure door is unlatched.
b. Select NO HEAT DRYING
option.
c. Slowly turn Cycle Indicator
Dial
to
RINSE &
HOLD
position.
d. Latch the door to start the cycle.
a. Push selected cycle button.
b. Latch the door.
To Next Page
Loading...
Need help?
General
