GE GTDP200GFWS - User Manual

For answers to your Monogram,
®
Cafe
™
Series,
Profile
™
Series or GE
®
appliance questions, visit
our website at geappliances.com or call
GE Answer Center
®
service, 800.626.2000.
370153
GTDP200GF
GE
®
6.8 cu. ft. capacity Dura Drum gas dryer
36
25-1/2
42
51
Side View
27
Rear View
36
42
27
2
3-1/2
2-1/2
25-1/2*
Side View
Rear View
8-1/2
28-1/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
Washer/Dryers SC QSart
5.7 cu. ft. Dryers
2
Back View
Power
Cord Hole
30-1/2
5.8, 6.0 and 7.0 cu. ft. Dryers
5
Back View
Power
Cord Hole
4-1/2
Power Cord Locations
Exhaust Option: When viewed from the front
of the unit, exhaust 3-way via rear, left and
bottom. Dryer is shipped exhausted to the
rear. Alternate exhausting knockouts are
supplied.
Gas: An individual, properly-grounded
branch circuit, with a three-prong grounding-
type receptacle, protected by a 15 or 20
amp circuit breaker or a time-delay fuse is
required.
Gas Dryer Electric Rating: 120V, 60Hz, 6A
Gas (BTU/HR): 22,000. Factory-equipped for
natural gas. Tested for LP gas. LP gas supply
requires a conversion kit. Check installation
instructions for correct kit and have a
qualified gas technician install a conversion
kit. See dryer ducting information for proper
installation.
Note: Dryer wall outlet must be located within
36" of service cord entry and accessible when
dryer is mounted in position.
Installation Information: For complete
information, see installation instructions
packed with your dryer.
Dimensions and Installation Information (in inches)
Specification Created 2/13

Summary

Dimensions and Installation Information

Exhaust Option

Dryer exhausts 3-way (rear, left, bottom). Shipped rear, alternate knockouts supplied.

Gas and Electrical Requirements

Requires grounded branch circuit, 120V, 60Hz, 6A. Gas 22,000 BTU/HR, factory-equipped for natural gas.

Installation Information

For complete information, see installation instructions packed with your dryer.

Power Cord Locations

Shows placement of power cord connection on the unit.

Ducting Materials and Exhaust

Exhaust Length Calculation

Determines maximum rigid duct length based on 90° turns. A turn over 45° counts as a 90° elbow.

Duct Termination and Safety

Avoid terminating exhaust into chimneys, attics, or common ducts. Use a dampered wall cap.

Special Installation Requirements

Alcove or Closet Installation

Specifies clearances and ventilation requirements for alcove/closet installations.

Bathroom or Bedroom Installation

Requires exhaust to outdoors and compliance with local/national codes.

Minimum Clearances

Details required clearances to combustible surfaces for non-alcove installations.

Dryer Exhausting Information

Guidance on using metal ducting and maximum vent lengths for different turns.

Features and Benefits

Dura Drum Interior

Durable drum construction with polypropylene-bead-reinforced finish for fabric protection.

Heat Selections

Provides multiple heat settings for various drying needs.

End-Of-Cycle Signal

Alerts user when the drying cycle is complete to prevent wrinkles.

Auto Dry Setting

Monitors air temperature to set optimal drying time for clothes.

GE GTDP200GFWS Specifications

General

Brand	GE
Model	GTDP200GFWS
Category	Dryer
Language	English