EasyManua.ls Logo

GE GTDP220GFWW User Manual

GE GTDP220GFWW
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
For answers to your Monogram,
®
Cafe
Series,
Profile
Series or GE
®
appliance questions, visit
our website at geappliances.com or call
GE Answer Center
®
service, 800.626.2000.
370155
GTDP220GF
GE
®
7.0 cu. ft. capacity Dura Drum gas dryer
36
25-1/2
42
51
Side View
27
Rear View
36
42
27
2
3-1/2
2-1/2
25-1/2*
Side View
Rear View
8-1/2
28-1/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
Washer/Dryers SC QSart
5.7 cu. ft. Dryers
2
Back View
Power
Cord Hole
30-1/2
5.8, 6.0 and 7.0 cu. ft. Dryers
5
Back View
Power
Cord Hole
4-1/2
Power Cord Locations
Exhaust Option: When viewed from the front
of the unit, exhaust 3-way via rear, left and
bottom. Dryer is shipped exhausted to the
rear. Alternate exhausting knockouts are
supplied.
Gas: An individual, properly-grounded
branch circuit, with a three-prong grounding-
type receptacle, protected by a 15 or 20
amp circuit breaker or a time-delay fuse is
required.
Gas Dryer Electric Rating: 120V, 60Hz, 6A
Gas (BTU/HR): 22,000. Factory-equipped for
natural gas. Tested for LP gas. LP gas supply
requires a conversion kit. Check installation
instructions for correct kit and have a
qualified gas technician install a conversion
kit. See dryer ducting information for proper
installation.
Note: Dryer wall outlet must be located within
36" of service cord entry and accessible when
dryer is mounted in position.
Installation Information: For complete
information, see installation instructions
packed with your dryer.
Dimensions and Installation Information (in inches)
Specification Created 2/13
Question and Answer IconNeed help?

Do you have a question about the GE GTDP220GFWW and is the answer not in the manual?

GE GTDP220GFWW Specifications

General IconGeneral
BrandGE
ModelGTDP220GFWW
CategoryDryer
LanguageEnglish

Summary

Dimensions and Installation Information

Power Cord Locations

Details the placement of the power cord connection point on the dryer unit.

Ducting Materials

Exhaust Length Calculation

Guidance on calculating maximum vent length based on turns and duct type.

Special Installation Requirements

Alcove or Closet Installation

Specific clearance and ventilation requirements for installing the dryer in alcoves or closets.

Bathroom or Bedroom Installation

Requirements for installing the dryer in bathroom or bedroom locations.

Minimum Clearances other than Alcove or Closet Installation

Specifies required clearances to combustible surfaces for standard installations.

Dryer Exhausting Information

Information on recommended ducting types and lengths for optimal dryer performance.

Features and Benefits

Related product manuals