49-90586 13
USING THE WASHER
Getting started
J
When selected, this feature will automatically add
detergent to the wash, eliminating the need to add
detergent for each load.
The detergent amount selection on the control panel
will default to AUTO when first powering up the washing
machine. When AUTO is selected, the amount of detergent
needed for each laundry load will automatically be
determined based on the size of the load the machine
senses.
If it is desired to manually select the amount of
detergent for a given load, this can be done by pressing
the Detergent Dispense button on the control panel to
select detergent for a Small, Normal or Large load. Small
will provide less detergent than average, Normal will
provide an average amount of detergent and Large will
provide more detergent than average.
The smart dispense feature can be disabled by pressing
the Detergent Dispense button until Off is selected.
NOTE: Not all cycles will allow the use of the
SmartDispense feature. If the light is illuminated below
the Off position and pressing the Detergent Dispense
button results in a beeping tone, then SmartDispense is
not allowed for the cycle that has been selected. Detergent
will need to be added directly to the wash basket for these
cycles.
This model does not have a dispenser drawer for detergent
since it has a bulk detergent dispensing system.
NOTE: If it is desired to manually add detergent for a
load, that detergent will need to be added directly to
the basket, and the smart dispense set to OFF for that
particular load.
NOTE: The right side of the dispensing area in the rear of
the washer opening does NOT pull out. It is a spout only
for water and detergent to flow from the smart dispense
system.
This machine is equipped with a bulk detergent reservoir
that can hold approximately 75 ounces of liquid detergent
for your convenience. This is enough detergent for about
50 average laundry loads, depending on what dispense
amount is selected.
The filling port of the detergent reservoir is located on the
front left of the washing machine. To fill the reservoir with
liquid detergent, first open the tank lid by rotating the small
lid clockwise. Then pour LIQUID detergent into the opening
until the level reaches the MAX indicator located inside
the filling port, also indicated with the horizontal line next
to the MAX lettering. Filling to this MAX level will provide
detergent for about 50 average laundry loads. To ensure
detergent is always available, liquid detergent should
be added to the reservoir whenever there is no longer
detergent visible when looking directly into the filling port.
NOTE: If it is desired to change detergent type in the
detergent tank, it is not required to flush the smart dispense
system. The new detergent type can be added to a partially-
filled tank, however it will not be immediately dispensed
until the original detergent is completely dispensed from the
system.
NOTE: In the event that excessive chlorine bleach is
accidentally spilled or otherwise gets into the detergent
tank, please follow the Detergent Tank Clean-Out
instructions in the Care and Cleaning section in order to
minimize the possibility for clothing damage. If only a few
drops of bleach are spilled into the detergent tank, there is
no need to flush the tank.
Adding Detergent to SmartDispenser™
(
GTW750 and GTW755 models only
)
Conditioner
MAX
Pretreatme nt
Water On Demand
Bulk Dispensing
Spout Only
Do NOT pull
SmartDispense™
(
GTW750 and GTW755 models only
)
To Next Page
Loading...
