GE GTWN4950L0WS - Fabric Softener Dispenser Operation

About washer features.
3 \
4 SETTINGS
OFF
I
2nd
RINSE
The Fabric Softener Dispenser (onsomemodels)
Thefabric softener dispenser automatically releasesliquid fabric softener at the proper time
during thecycle.
Do not stop the washer or raise the lid during the first spin. This will cause the dispenser to
empty
tOO soon.
Never pour fabric softener directly on clothes. This may cause stains on your clothing.
To use, follow these steps:
r_-i Liftthe tab on the fabric softener
dispenser top.
Measureout fabric softener into
the cap and pour the softener into
the dispenser top. The fabric softener
will drain into the receiving cup inside
the dispenser.Useonly "Ultra" or
concentrated fabric softeners.
NOTE:Overfilling the dispenser will cause
fabric softener to drain out of the holes inthe
sideof the infusor when filling. Do not overfill.
%
Pushdown on the tab to close
the dispenser top. Makesure the tab
ispushed down fully and snaps shut.
I_-I SelectFABRICSOFTENERfrom SETTINGS
on the control panel.
6
TurningTabs
TurningTabs
Cleaning the Fabric Softener Dispenser (onsomemodels)
The Fabric Softener Dispenser is self cleaning. This dispenser does not require regular cleaning
like standard fabric softener dispensers. Wipe down exterior surfaces of the dispenser
as needed. If cleaning of the internal dispenser components is needed, follow these steps
after the wash cycle is complete:
B]
Liftthe dispenser top tab and turn the top
counterclockwise usingthe 2turning tabs
shown. Liftthe dispenser out of the
InfusorTM.
Cleanout any buildup from inside the
InfusorTM with a soft cloth or toothbrush.
Ensurethe three rectangular holes
in the bottom which allow the fabric
softener to drain are not blocked.
Gently pullthe cap away from
the dispenser cup to separate.
Wipe surfaces with a soft cloth or soak
the parts in a solution of i gallon warm
water, 1/4 cup liquid detergent and 1 cup
bleach. Ensurethe small hole in the top
surface of the cap and associated tube
are not obstructed.
Reassemblethe dispensercup and cap
by snapping them together.
Placethe dispenser assembly into
the InfusorTM. Turn the top clockwise
usingthe 2 turning tabs shown. Push
down on the tab to closethe dispenser
top. Makesure the tab is pushed down
fully and snaps shut.