GE GUD27ESSM User Manual

Listed by
Underwriters
Laboratories
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
GUD27ESSM/27GSSM
GE
®
Unitized Spacemaker
®
3.8 DOE Cu. Ft. Stainless Steel Washer and 5.9 Cu. Ft. Dryer
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
Specification Revised 11/17
ELECTRICAL REQUIREMENTS:
GUD27ESSM Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V or 120/208V
single-phase 60 Hz electrical service and should be protected by
30-amp time-delay fuses or circuit breakers KW Rating per voltage
(240/208). This appliance is manufactured with neutral connected to
the frame. Power cord should be purchased separately.
GAS REQUIREMENTS:
GUD27GSSM Gas Dryer – This appliance should be connected to an
individual branch circuit with 120-volt single-phase 60 Hz electrical
service and should be protected by 20-amp time-day fuses or circuit
breakers. This appliance is equipped with a 4-foot long flexible U.S.
listed 20-amp power cord to match a 20-amp receptacle.
NOTE: Gas Rated input 20,000 BTU/HR. Factory equipped for natural
gas. Tested for LP gas. LP gas supply requires a conversion kit. Have a
qualified gas technician install a conversion kit before use.
Dryers must be exhausted to the outside.
INSTALLATION INFORMATION: For complete information, see
installation instructions packed with the product.
Installation Instructions
* Dimension represents door closed including handle and knobs.
NOTE: With feet set at mid position, feet can be adjusted +/- 3/8".
27" NOMINAL PRODUCT DIMENSIONS
Vent
Drain outlet
51°
Gas Inlet
Water Inlets
*26-1/8"
34-3/8"4-3/8"
3"
47 1/2"
18-5/8"
12-1/2"
75-7/8"
53-1/4"
3-7/8"
36-7/8"
30-7/8"
26-3/4"
22-1/4"
3"

GE GUD27ESSM Specifications

General

Brand	GE
Model	GUD27ESSM
Color	White
Dryer Venting	Vented
Number of Cycles	4
Energy Star Certified	No
Width	27 in.
Depth	30 in.

Summary

GE Unitized Spacemaker Dimensions and Installation

Electrical Requirements

Details electrical connection and protection for the dryer, specifying voltage and circuit breaker requirements.

Gas Requirements

Specifies gas connection, protection, and conversion needs for the gas dryer model, including BTU rating.

Product Dimensions

Provides key physical dimensions for the 27-inch nominal product, including height, width, and depth.

Dryer Venting and Exhaust

Ducting Materials

Recommends using 4" diameter rigid metal exhaust duct for best performance and specifies alternatives.

Exhaust Length Calculation

Explains how to calculate maximum allowable vent system length based on turns and duct type.

Exhaust Safety Precautions

Warns against terminating exhaust into chimneys, crawl spaces, or attics due to fire and moisture hazards.

Special Installation Scenarios

Alcove or Closet Installation

Details minimum clearances, louvered door requirements, and ventilation for alcove/closet installations.

Bathroom or Bedroom Installation

Specifies exhaust requirements and compliance with local codes for these installation locations.

Minimum Clearances

Outlines the minimum clearances required to combustible surfaces for non-alcove/closet installations.

Washer and Dryer Features

Dryer Features

Highlights rotary-electromechanical controls for easy cycle selection on the dryer.

Washer Features

Lists wash cycles, temperatures, speed combinations, and auto-load sensing for the washer.

Dispenser and Status Lights

Describes bleach/softener dispensers and cycle status lights for improved user experience.