GE IC3645SH7R354D2 - Page 18

DIAGNOSTIC STATUS CODES
SX TRANSISTOR CONTROL Page 18
April 2002
TRACTION
STATUS CODE
DESCRIPTION OF STATUS CAUSE OF STATUS INDICATION
-09
Both the forward and reverse switches
are closed at the same time.
This status code will be displayed when P4 and P5
are less than 7.2 volts, and P7 is less than 2.5 volts.
MEMORY RECALL
NO
CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAM
Circuits valid
for
Traction
Controller
SYMPTOM
Control will not operate.
POSSIBLE CAUSE
Accelerator pedal is depressed before
closing forward or reverse directional
switch.
•= Status code will disappear when
directional switch is closed or when
accelerator pedal is released.
Defective directional switch
•= Check forward or reverse switch to insure
closure when direction is selected.
Open circuit between directional switch(es)
and 12V positive or between directional
switch(es) and P4 or P5.
•= Check all control wires and connections
shown in Trouble Shooting Diagram.
L
TURF SPEED LIMIT SWITCH *
KEY SWITCH *
START SWITCH *
DIRECTIONAL
SWITCH *
FORWARD
REVERSE
N.C. MOTOR
THERMOSTAT
*
BUZZER *
AUX ACCEL POT *
ACCEL POT *
P1 P2 P3 P4 P5 P21 P11 P10
P15
TACHOMETER *
P14
+12V
P16 P7 P9 P13 P8 P6
RED
GREEN BLACK
PLUG (23 PIN)
*
TRACTION
STATUS CODE
DESCRIPTION OF STATUS CAUSE OF STATUS INDICATION
-11
Start switch closed on power up after initial
key switch closure.
This status code will be displayed when P3 is
greater than 7.2V when the key switch is closed.
MEMORY RECALL
NO
CORRECTIVE ACTIONS TROUBLE-SHOOTING DIAGRAM
Circuits valid
for
Traction
Controller
SYMPTOM
Control will not operate.
POSSIBLE CAUSE
Start switch is mis-adjusted or defective.
•= Input voltage at P3 should be less than
7.2V at key switch closure. Adjust or
replace accelerator unit to insure that the
voltage at P3 is less than 7.2V before
closing the start switch.
Short circuit between P15 and P3 in start switch
input circuit.
•= Disconnect wire from P3. Check for short
circuit from this wire to 12V positive.
Resistance should be greater than 4.7K
ohms.
Defective control.
•= Disconnect wire from P3. Measure voltage
from P3 to negative. Voltage should be
zero. If not, replace the control.
L
TURF SPEED LIMIT SWITCH *
KEY SWITCH *
START SWITCH *
DIRECTIONAL
SWITCH *
FORWARD
REVERSE
N.C. MOTOR
THERMOSTAT
*
BUZZER *
AUX ACCEL POT *
ACCEL POT *
P1 P2 P3 P4 P5 P21 P11 P10
P15
TACHOMETER *
P14
+12V
P16 P7 P9 P13 P8 P6
RED
GREEN BLACK
PLUG (23 PIN)
*