Before you call for service…
38
Problem Possible Causes What To Do
Oven temperature too Oven thermostat • See the Adjust the oven thermostat―Easy to do
hot or too cold needs adjustment. yourself! section.
Clock and timer do Plug on range is not completely • Make sure electrical plug is plugged into a live, properly
not work inserted in the electrical outlet. grounded outlet.
A fuse in your home may be • Replace fuse or reset circuit breaker.
blown or the circuit breaker
tripped.
Oven controls improperly set. • See the Using the clock, timer and convenience outlet
section.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is turned off from • See the Using the clock, timer and convenience outlet
showing in the display. section.
Oven door is crooked The door is out of position. • Because the oven door is removable, it sometimes
gets out of position during installation. To straighten
the door, push down on the high corner.
Oven makes This is the sound of the • This is normal.
clicking noise heating element turning
off and on during
cooking functions.
“F―and a number You have a function error code. • Press the OFF pad. Put the oven back into
or letter” flash in operation.
the display
If the function code repeats: • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
• On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as far as it will go. Press the
OFF pad. Allow the oven to cool for one hour. Put
the oven back into operation.
Power outage
clock flashes
Power outage or surge. • Some models will automatically resume their setting once
the power is restored. On models with a clock, you must
reset the clock. If the oven was in use, you must reset it by
pressing the OFF pad, setting the clock and resetting any
cooking function.
Display flashes Power failure. • Reset the clock.
Unable to get the display Oven control pads were not • The BAKE and BROIL pads must be pressed
to show “SF” pressed properly. at the same time and held for 3 seconds.
Troubleshooting Tips
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions
Safety Instructions
To Next Page
Loading...
Need help?
General
