Beforeyoucall forservice...
Troubleshooting -tips
Possible Causes What To Do
"LOCKDOOR_'flashes The self-cleaJa cycle has been * Close the oxen door.
in the display selected hut the door is not
closed.
LOCKED DOOR light The oven door is locked
is O0 when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
• Touch the CLEAR/OFFpad. _Mlow the oveu to cool aud
then, on models with a door latch, unh)ck the dooI:
Oven door willnot Oven is too hot. • _Mlow the oven to cool beh)w locking temperature.
unlock (on models Do not lock the door with the door latch except when
with a door latch) usiu,, the xelf_cleau feature.
"Door"appears in the Self-clemahag cycle has been • Move tile latch haudle :ill tile way tl) tile right.
display (on models selected but the latch handle
with a door latch) was not moved all the way
to the right.
Latch handle was moved to the • Move the latch haudle to tile right only when ,setfiw,
right but a program other than the sell:cleaning cycle.
self-clemahag was selected.
"T--and a number or On models with a door latch, • The latch may have been moved, exeu if only slightly,
letter"flash in the display if a function error code appears fi'om the h)cked position. Make sure the latch ix moved
during the self-clemahag cycle, to tile right as flu"as it will _o
check the oven door latch.
You have a function error code. • Touch the CLEAR/OFFpad. ?dlow the oven to cool for
oue hl)uI: Put the oveu back iuto operatiou.
If the function code repeats. • Dixclmne('t ;Ill pi)wer tl) the r;mge for 5 minutes
;lud theu l'e('l)uue('t pl)wel: It the _'Hu('til)u elTOl"
code repeats, call for service.
Oisplaygoes blank A fuse ha your home may be • Replace the fl/xe or reset tile circuit l_reakel:
blm_a or the circuit
breaker tripped.
The clock is hathe • See the Special features of your oven controlsectiou.
black-out mode.
Display flashes Power failure. • Reset the (lock.
Unable to getthe Oven control pads were • The BAKE and BROILHI/LO pads must be touched at
displayto show "SF" not touched properly, tile same time and held fin" 3 seconds.
• Reset tile clock. If the ()x'ell was ill use, yl)u must reset
it by touchiug tile CLEAR/OFFpad, .settiw_ tile clock :rod
resetting any cl)l)king flmction.
Poweroutage, Power outage or surge.
clockflashes
46
To Next Page
Loading...
