8
Consumer Support
Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Be sure you turn the control knob to
OFF when you finish cooking.
Using the surface units.
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both OFF and MAX the control clicks
into position. You may hear slight clicking
sounds during cooking, indicating the
control is keeping the power level you set.
A HOT surface indicator light, on
the cooktop, will glow when any radiant
element is turned on. It will remain
on until the surface is cooled to
approximately 65.5°C (150°F).
Hot surface indicator light will:
■ come on when the unit is hot to the touch.
■ stay on even after the unit is turned off.
■ glow until the unit is cooled to approximately
65.5°C (150°F).
WARNING: The surface
units are automatically disabled during
the self-clean cycle. Make sure that all
surface unit controls are turned off at all
times during the self-clean cycle. Any
surface unit that is set to an on position,
while the self-clean cycle is operating, will
automatically come on after the self-clean
cycle is finished, and could result in an
on, unattended surface unit. Wait until
the self-clean cycle is finished to set and
use the surface units.
To Next Page
Loading...
