EasyManuals Logo

GE JCP930 Owner's Guide

GE JCP930
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
Cleaning the glass cooktop.
www.GEAppliancescanada.com
Allow the cooktop to cool.
Spread a few drops of Cerama
Bryte® to the entire burned residue
area.
Hold the razor scraper at
approximately a 45° angle against
the glass surface and scrape the
soil. It will be necessary to apply
pressure to the razor scraper in
order to remove the residue.
Keep a small amount of cream on
the residue as you scrape.
After scraping with the razor
scraper, use the scrub sponge to
remove any remaining residue.
For additional protection, after all
residue has been removed, polish
the entire surface with Cerama
Bryte® and a paper towel.
Burned-On Residue
WARNING: DAMAGE to your glass surface
may occur if you use scrub pads other than
BLUE Scotch-Brite
®
Multi-Purpose No Scratch
scrub sponges by 3M.
Allow the cooktop to cool.
Spread a few drops of Cerama
Bryte® to the entire burned residue
area.
Using the scrub sponge, rub the
residue area, applying pressure as
needed.
If any residue remains, repeat the
steps listed above as needed.
For additional protection, after
all residue has been removed,
polish the entire surface with
Cerama Bryte® and a paper towel.
NOTE: Razor blade is packed
inverted for safety reasons. Prior to
use, the blade must be rotated and
reinserted into slot. Do not use a
dull or nicked blade.
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under “To Order Parts”
section on next page.
Heavy, Burned-On Residue
Scotch-Brite
®
Multi-Purpose
No Scratch scrub sponge
Normal Daily Use Cleaning
ONLY use the recommended cleaning
cream, Cerama Bryte®, on the glass
cooktop. Other creams may not be as
effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with the cooktop
cleaning cream. This helps protect
the top and makes clean-up easier.
Daily use of the cooktop cleaning
cream will help keep the cooktop
looking new.
Shake the cleaning cream well.
Apply a few drops of the cream
directly to the cooktop.
Use a paper towel or sponge to clean
the entire cooktop surface.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Clean your cooktop after
each spill.

Other manuals for GE JCP930

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE JCP930 and is the answer not in the manual?

GE JCP930 Specifications

General IconGeneral
BrandGE
ModelJCP930
CategoryCooktop
LanguageEnglish

Related product manuals