GE JGP989 - Installation; Parts Included; The Cooktop

Installation Instructions
UNPACKING YOUR COOKTOP
PARTS INCLUDED (PACKED BELOW THE COOKTOP)
• Blower assembly
• Blower plenum
• (4) Nuts (10-32 keps - nuts
with lock washers attached)
• (2) Hold-down retainers and
thumb screws
• (9) Sheet metal screws
(8-18 x 3/8")
• Foam gasket tape (9-ft. roll)
• Vent grille
• Vent filter
• Vent grille gasket
• Cleaning cream
• Scrub sponge or scraper
(on some models)
• Burner grates
• Burner heads
(1 small (A), 2 medium (B),
1 large (C))
• Burner caps
(1 small, 2 medium, 1 large)
• Gas pressure regulator
• Attached 120-volt grounded
plug cord
• LP Conversion
• Reflective tape
Reflective
Tape
Sheet Metal
Screws (9)
(8-18 x 3/8")
Hold-Down
Retainers and
Screws
Cleaning
Cream
Scrub Sponge
CAUTION: GLASS
IS FRAGILE
DO NOT BUMP EDGE
OF GLASS DURING
INSTALLATION
Vent Grille
Burner /_[==_C===7/==_
Grate /_1
t2t
@
Foam Gasket Tape
Vent Grille Gasket
L
Burner Caps and Burner Heads
Regulator
CAUTION:
DO NOT LIFT
FROM VENT
OPENING
Burner Cap and Burner Head
Burner Cap and Burner Head
@@
@@
Blower Assembly and
(4) Mounting Nuts
(10-32 keps - nuts with
lock washers attached)
Blower
16 Plenum
Vent
Filter