GE JGSP28 Installation Instructions

Installation Instructions
INSTALL THE RANGE (CONT.)
[]
[]
SUDE {RANGE INTO OPENING
Position the range in front of the cabinet
opening.
[] Make sure that the cooktop edges that
overhang the countertop clear the
countertop. If necessary, raise the unit
by lowering the leveling legs.
[] Push while lifting the range into the
opening, until the range is within 2"
of engaging the anti-tip bracket.
[] Remove the protective trim from the side
of the cooktop (if provided).
[] Using the adjustable pliers or wrench,
carefully screw in the back leveling leg
until the cooktop overhang comes to rest
on the countertop.
Adjustable
wrench or pliers
[] Carefully screw in the front two leveling
legs (similar to Step E) until the cooktop
overhang touches the countertop.
[] Carefully push the range into the opening
until the anti-tip bracket engages and the
vertical sides are flush with the cabinet.
Countertop
Cabinet
r_ SLIDE RANGE INTO OPENING
(cont.)
[] Plug the range cord into the
receptacle.
Locate the cord in the back of the range
in a manner that it will not touch or be
moved by the drawer.
Position range cord
so that there is no
interference with
_1 storage drawer _.
///////////////////////////////////////////////
\
.\
\
tll
\/
I-Q
\
/I/
/// /////
r_-z-4]FINAL CHECK OF ANTI-TIP
BRACKET
When installation is complete and the range is
in place, check to be sure that the rear leveling
leg is fully inserted into the slot of the Anti-Tip
Bracket.
10

GE JGSP28 Specifications

General

Brand	GE
Model	JGSP28
Category	Ranges
Language	English