The COOKCODET”Control pro-
videsa short-cut method for
entering time and the Power Level
on your microwave oven. Cooking
Codes are only used for recipes
which need little or no attention,
and which require no change of
power level during cooking.
Recipes which require additional
ingredients, attention or change of
power level during microwaving
should be cooked in the usual
manner. Also, recipes with cooking
time of less than one minute or
more than 99 minutes can not use
Cooking Codes.
To understand the Cook Code con-
trol, it is important to know what
the numbers mean and what the
sequence is. The first and second
numbers, if setting a 3 digit Cook-
ing Code, indicate the amount of
time you.desire; the last control
entry number is always the Power
Level. For example, 125means
COOKING CODE
2-Digit
Time in
Power Level
Minutes High (10)
How to set
COOK
CODETMControl
P oven for COOK
CODETMControl operation is easy.
Follow these simple steps.
Step 1:Touch COOK COD.E.
ENTER CODE flashes.
12minutes at Power Level5. NOTE:
Your oven can only be programmed
to 99 minutes when using the Cook
Code control and the highest Power
Level is 10which is represented by
“O”.When setting a 2 digit Cook
Code control entry, the first is time,
the second is power level. For
example, 50 means 5 minutes at
Power Level 10.
On the following page is shown
many frequently prepared foods
and their codes. It’s easy, though,
to make Cooking Codes for many
other recipes. Just select one or two
digits representing the length of
cooking time desired, and a final
digitfor the Power Levelrequired.
The Cooking Codes given on the
chart are for the minimum time
needed, to avoid overcooking which
can dry out food and make it taste-
less and tough. If you feel that
more cooking is needed, add addi-
tional time by changing the first
digit of the Code. You cannot add
seconds to the cycletime—Cooking
Codes are for whole minutes only.
If your recipe calls for Power Level
changes or different amounts of
time needed between addition of
ingredients, you may set one Cook-
ing Code for the first part of the
recipe, then after completion, set
another Cooking Code for that
period of time and Power Level.
Remember that Cooking Codes are
for microwaving by time only. If
you are microwaving by tempera-
ture, you must use th~ Temp Cook
or Auto Roast function.
When the oven completes COOK
CODETMprogram, it automatically
shuts off. It will then display “End”
and beep once a minute until you
either open the door or touch the
CLEAR/OFF pad.
COOKING CODE
3-lXgit
Time in Power Level
Minutes
Nled (5)
Step2:Enterthe propercode.For
example,a recipecallingfor 12min-
utes cooking ti~e at Po-werLevel
10would be 120. 120appears on
the display panel.
14
WES.
Step 3: Touch START. Display will
show time countinq down a-rid-
COOK TIME. -
~