-
———
E -
F
-
i
E
S
_
o v Duct
The oven is vented through a duct
that’s located on the right side.of
the oven just above the door handle
(see page 6). Moisture and vapors
from the oven are vented through it
IndentedArea
6
E
—
-
when oven is in use. Never cove;
the hole in the duct. To do so pre-
vents it from functioning properly
during cooking and cleaning.
Ump R@acemxnt
CAIJT’ION:Before replacing
your ovenkunp bulb, disconnect
the electric power for your
Cooking Center at the main fuse
or circuit breaker paneL Be sure
to let thelamp coverand bulbcool
completely beforeremovingor
replacing them.
*
w
-
-
-–
-
E
If you wish, you may line the
broiler pan with aluminum foil and
cover the rack with it for broiling.
ALWAYSBE SURE TO MOLD
THE FOIL THOROUGHLY TO
THE BROILER RACK AND
SLIT THE FOIL TO CONFORM
WITH SLITS IN THE RACK.
Stopping fat and meat juices from
draining into the broiler pan pre-
vents the rack from serving its pur-
pose and MAY LET JUICES
BECOME HOT ENOUGH TO
CATCH FIRE.
-
—.
E
(Areaseenthroughglasscontrol
panelafterknob is removed.)
-.—.
-.
-
-
The temperature on your new oven
has been accurately set at the fac-
tory. However, if your food con-
sistently browns too much or too
little, you may make a simple ad-
justment behind your OVEN
TEMP Knob. To readjust your
thermostat:
—.
Wia?a
—-—
~ Rotate OVEN TEMP Knob to
-- i.F,4N position and pull knob off
yhe shaft revealing area behind
a 3/16”standard
Theovenlamp(bulb) is covered
with a glass removablecoverwhich
is held in place with a.bail-shaped
wire. Removeovendoor, ifdesired,
to reach cover easily.
screwdriver, into the indented area
directly under the notch and turn in
the desired direction. Be careful not
to scratch glasscontrol panel.
@To increase oven temperature
move dial one notch counterclock-
wise.To lower oven temperature,
move dial one notch
c
(Each notch represents approxi-
mately 150.)
TOremove:
@+Holdhandundercoversoit
doesn’tfallwhenreleased.With
fingersofsamehand,firmlypush
backwirebailuntilit clearscover.
Liftoffcover.DONOTREMOVE
ANYSCREWS‘TVREMOVE
COVER.
—————
* Return knob to the range by
matching the flat area of the knob
to the shaft.
@Recheck oven performance
before making an additional
adjustment.
@Replace bulb with 40-watthome
appliance bulb.
Torepktcecover:
@Placeit into grooveof Iamp
receptacle. Pull wire bail forward
to center of cover until it snapsinto
place. When in @ace, wire holds
cover firmly. Be certain wire bail is
in depression in center of cover.
@Connect electric power to oven.
To Next Page
Loading...
Need help?
General
