Why is there a strong odor coming from my GE JS760DLWW oven?
If you notice a strong odor from your GE Ranges, it is likely due to the insulation around the inside of the oven, which is normal for the first few uses. This is temporary and will go away after several uses or a self-clean cycle.
What to do if GE JS760DLWW oven door will not open after a clean cycle?
If your GE Ranges oven door won't open after a clean cycle, it's likely because the oven is still too hot. Allow the oven to cool below the locking temperature.
What to do if surface units on my GE Ranges do not work properly?
If the surface units on your GE Ranges aren't working, first check your home's fuse box or circuit breaker and replace the fuse or reset the breaker if needed. Also, ensure the cooktop controls are correctly set for the specific surface unit you're trying to use.
What does “F— and a number or letter” mean on my GE Ranges display?
If “F— and a number or letter” flash in the display of your GE Ranges, it indicates a function error code. Press the Cancel/Off pad and allow the oven to cool for one hour before putting it back into operation. If the function code repeats, disconnect all power to the oven for at least 30 seconds and then reconnect power. If the error persists, call for service.
Why is there steam coming from the vent of my GE Ranges oven?
When using the ovens in your GE Ranges, it is normal to see steam coming out of the oven vents. As the number of racks or amount of food being cooked increases, the amount of visible steam will increase.
Why is there water remaining on oven floor after Steam Clean cycle of GE JS760DLWW Ranges?
If you notice water remaining on the oven floor after the Steam Clean cycle in your GE Ranges, don't worry, this is normal. Remove any remaining water with a dry cloth or sponge.
What causes excessive smoking during the clean cycle on my GE JS760DLWW Ranges?
If there is excessive smoking during the clean cycle of your GE Ranges, press the Cancel/Off pad and open the windows to rid the room of smoke. Wait until the LOCKED light goes off, then wipe up the excess soil and reset the clean cycle.
How to broil food properly in GE JS760DLWW?
To broil food properly in your GE Ranges, ensure you select the appropriate broil mode and use the correct rack position. Make sure food is cooked in a cool pan specifically designed for broiling. If using aluminum foil on the broiling pan and grid, ensure it has been fitted properly and slit as recommended. In some areas the power (voltage) may be low, preheat the broil element for 10 minutes.
What to do if plastic melted to the surface of my GE Ranges?
If plastic has melted to the surface of your GE Ranges, it's because the hot cooktop came into contact with plastic. See the Cleaning the glass cooktop section as there is potential for permanent damage without proper care.
Why GE JS760DLWW Ranges oven will not self-clean?
If your GE Ranges oven won't self-clean, it could be due to a few reasons. If the temperature is too high, allow the oven to cool and reset the controls. Make sure the door is completely shut.
General| Style | single oven, slide-in |
|---|---|
| Color | white, white on white |
| Total Capacity | 5.3 cubic feet |
| Induction | no |
| Interior Light | yes |
| Fuel | electric |
| Voltage | 208 volts |
| Current | 40 amperes |
Weight and Dimensions| Depth | 28 1/4 inches |
|---|---|
| Height | 37 1/4 inches |
| Width | 29 7/8 inches |
| Net Weight | 179 pounds |
To Next Page
