OVEN CONTROL, CLOCK
Am
T~ER
Clock
To Set the Clock
The clock must be set for the automatic oven timing
❑
1.
Press the CLOCK pad.
functions to work properly. The time of day cannot be
changed during a Timed Baking or Self-Cleaning cycle.
CLOCK
A
2. Press the INCREASE or DECREASE
pad to set the time of day.
@
Timer
To Set the Timer
The timer is a minute timer; it
❑
1.
Press the TIMER
does not control oven operations.
;~Mo:~
ON/OFF pad.
The maximum setting on the timer
is 9 hours and 55 minutes.
A
A
2. Press the INCREASE
or DECREASE pad
@
to set the amount of
time on the timer.
v
e
The timer will start automatically
within a few seconds of releasing the
INCREASE or DECREASE pad. The
timer, as you are setting it, will display
seconds until one minute is reached.
Then it will display minutes and
seconds until
60
minutes is reached.
Afier
60 minutes, it will display hours
(“HR” now appears in display) and
minutes until the maximum time of
9 hours and 55 minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
Press
and
hold the TIMER ON/OFF pad until the
DECREASE pad until desired time is reached.
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
Display Messages
The end of cycle tone is a series of three beeps
●
If “clean” appears in the display, DOOR flashes
followed by one beep
every six seconds. If you would
and the
oyen
control signals, you set the self-clean
like to remove the signal that beeps every six seconds,
cycle and did not shut the door.
press and hold the CLEAR/OFF pad for
10
seconds.
●
H
“LOCK”
ody
appears in the display, the oven door
To return the signal that beeps every six seconds,
is in the locked position. BAKE, BROIL and COOK
press and hold the
CLEAWOFF
pad for
10
seconds.
TIME cannot be set if
the door is in the locked position.
Power Outage
After a power outage, when power is restored, the
The display flashes until the clock is reset. All other
display will flash and time shown will no longer be
functions that were in operation when the power went
correct—for example, after a 5-minute power
out will have to be programmed
again.
interruption the clock will be 5 minutes slow.
18
To Next Page
Loading...
