CARE AND CLEANING
(continued)
Glass Window Painted Surfaces
To clean the outside of the oven window, use a glass
cleaner. Rinse and polish with a dry cloth.
Do not allow the water or cleaner to run down
inside the openings in the glass or the openings in
the top of the oven door while cleaning.
Painted surfaces include the outside of the oven door
and the control panel. Clean these with soap and
water or a vinegar and water solution. Do not use
commercial oven cleaners, cleansing powder, steel
wool or harsh abrasives on any painted surface.
Control Panel
It's a good idea to wipe the control panel after each use. Clean with mild
soap and water or vinegar and water, rinse with clean water and polish dry
with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers, plastic scouring
pads or oven cleansers on the control panel--they will damage the finish
A 50/50 solution of'vinegar and hot water solution works well.
Oven Light Bulb
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
The light bulb is located on the top of the oven. Before
replacing the bulb, disconnect electrical power to the
oven at the main fuse or circuit breaker panel. Let the
bulb cool completely before removing it. For your
safety, do not touch a hot bulb with a damp cloth. If
you do, the bulb will break.
To remove: Turn to remove the cover, then remove
the bulb.
To replace: Put in a new 40-watt appliance bulb.
NOTE:
• A 40-watt appliance bulb is smaller than a standard
40-watt household bulb.
• Install and tighten the cover.
• Reconnect electrical power to the oven.
_Socket
I
Bulb I-4"
_" Max. length
I
!
Glass I
cover
28
To Next Page
Loading...
Need help?
General
