GE JTP44 Use And Care Guide

OVEN CONTROL, CLOCK AND TM
ulock
To Set the Clock
q
The clock must be set for the
automatic oven timing functions to
work properly. The time
of day
cannot be changed during a Timed
n
1. Press the CLOCK
CLOCK
pad.
A
A
2. Press the INCREASE
g
@
or DECREASE pad
to set the time of day.
g
m
Baking or Self-Cleaning cycle.
w
m
o
~
w
3. Press the CLOCK pad to start.
Timer
To Set the Timer
The timer is a minute timer only.
The timer does not control
oven operations. The maximum
D
1. Press the TIMER
The timer
starts immediately; the
:ly~;
ON/OFF pad.
words SET TIME go off after
about one minute.
A
setting on the timer is 9 hours and
55 minutes.
2. Press the INCREASE or
The timer will display hours and
DECREASE pad to set the
minutes as it counts down until the
amount of time on the timer.
last minute is displayed, then it
displays seconds.
T. Reset the Timer
Ii “TIMER” is displayed, press the INCREASE or
DECREASE pad until the desired time is reached.
To Cancel the Timer
Press and hold the TIMER ON/OFF pad until the
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
The End of Cycle tone is a series of 3 beeps followed by I beep every
6 seconds. If you would like to remove the signal that beeps every 6
seconds, press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press and hold the
CLEAWOFF pad for 10 seconds.
Power Outage
After a power outage, when power is restored, the display will flash
and time shown will no longer be correct—for example, after a 5-minute
power interruption the clock will be 5 minutes slow.
All other functions that were in operation when the power went out
will have
[o be programmed again.
(( O1lf;/7ilc,(l /1(,.\’l /7(1(s(, )
7
—

GE JTP44 Specifications

General

Brand	GE
Model	JTP44
Category	Oven
Language	English