Usingthe downdraft system.
On some models, the RAISE/LOWER
switch is located at the top right of
the vent,
iii ii! i
RAISE/LOWERSwitch (3o"models only)
Tmn tile dox_ll(hafi blower ON by pressing
the PAISE/LOWER switch located at the top
right of the vent (oil some models). Place
y{)ur finger oil the "center" of the s_xitch
and hold until you observe the vent rot)ring,
then release. The air vent will rise. Use the
sele(tor s_dtch to mrn tile blower ON,OFF
or to dlange the blower speed.
Tile vent may be lowered by again pressing
the PAISE/LOWERs_a_itchat the top right side
of the vent. The blower, if left on, will
mltomafically go offwhen tile vent is
lowered.
NOTE:Formostconvenientoperation,set the
blower tothespeedyou use most often. The
blower will come onto thisspeedwhenever
theunit israised.
RemoteRAISE/LOIIVERswitch
(36"modelsonly)
36" models havea remote RAISE/LOWER
sx_ch. I_ operates in _t_esame manner as
fl_es_dt(:h lot ated on the vent.
RAISE/LOWERswitch location may vary,
Use the selector switch to turn the
blower ON,OFFor to change the
blower speed,
Using the Cooktop
Caution
Be caretnl when raising or lowering tile
dox_lldrafl. Be sure pots, pot handles and
other objecls are clear of tile do_ll(hafl and
cannot be su_uck or tipped by the dox_lldrafi
being raised.
NOTE"Thereis a slight trimoverhangat each
end ofthe vent.
To avoid h-tj_v, be sure f'mgers are clear
of the dow_draft cover when it is behrig
lowered.
Keep hands and f'mgers away from all
downdraft parts.
To Next Page
Loading...
Need help?
General
