Installation Instructions
ALIGNING THE WALL PLATE
HoleC Centerline
Notches
Drawa Vertical
LineonWall
'.<-_ from Centerof
TopCabinet
Hole B
0000000
000000000
!
AreaE HoleD
CAUTION: Wear gloves
to avoid cutting fingers on
sharp edges.
[]Draw a vertical line on file wall at the center of the
30" wide space.
[]Use the mounting plate as the template for the rear
waU. Place the mounting plate on tim waU, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and centerline
on the bottom of the mounting plate to the centerline
on the wall.
[] While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D
(see illusuation above/acatal plato marked with
arrows). Four holes must be used for mounting.
[]
NOTE: Holes C and D are inside area E. If neither
C nor D is in a sutd, find a sutd somewhere in area E
and draw a fifth circle to line lap with the stud. It is
important m use at least one wood screw mounted
firmly in a stud m support the weight of the microwave.
Set the mounting plate aside.
Drill holes on the circles. If there is a stud, drill a X_/'
hole for wood screws. For holes that don't line up with
a sutd, drill a %" hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
10
To Next Page
Loading...
Need help?
General
