GE JVM1950 - Page 20

Installation Instructions
C3| ADAPTING BLOWER
FOR RECIRCULATION
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want
to save them for possible future use.
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
Blower Plate
Blower
/ Motor Screw
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
Roll the blower unit 90° so that fan blade openings
are facing out the back of the oven.
AFTER: Fon Blade
Openings Facing
Forward
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
Place the blower unit back into the opening.
AWARN ING risk of electric shock
can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wired are
not pinched.
Close the blower plate. Secure with the screw
removed earlier.
Blower Plate
20