GE JVM1950 - Page 21

Installation Instructions
MOUNT THE OVEN
C4
ACAUTI ON: To avoid the risk of personal
injury (back injury or other injuries due to excessive
weight of the microwave] or property damage, you
will need two people to install this microwave.
IMPORTANT: Do not grip or use handle curing
installation.
AWARN ING risk of electric shock.
Can cause injury or death: If installing unit
with metal countertops, cover the edge of the
power supply cord hole with the power supply cord
bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting
the microwave, thread
power cord through hole
in bottom of top cabinet.
Keep it tight throughout
Steps 1-3. Do not pinch
cord or lift oven by pulling
cord.
Lift microwave, tilt it
forward, and hook slots
at back bottorn edge
onto four lower tabs of
mounting plate.
Rotate front of oven up
against cabinet bottom.
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
Cabinet Front
Cabinet Bottom Shelf
Filler Block
A This distance
Equivalent
can
NOT
fo
Depth
exceed
2”
of
Cabinet
proper
Recess
Winstallation
Self-Aligning Screw
Oven Top
Insert 2 self-aligning screws
(%4"-28 x 25%") through outer
top cabinet holes. Turn two full
turns on each screw.
Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet)
Install grease filters. See the Owner’s Manual
packed with the oven.
21