1
LUR Series
Lumination
TM
LED Luminaire
Installation Guide
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
RISK OF FIRE OR ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
• Follow all NEC and local codes.
• Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit installation. Do not leave any
other open holes in an enclosure of wiring or electrical components.
• LUR LED retrot kit installation requires knowledge of luminaires electrical systems. If not qualied, do not attempt installation. Contact a
qualied electrician.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where
the input rating of the retrot kit does not exceed the input rating of the luminaire.
• Use only UL approved wire for input/output connections. Minimum size 18 AWG or 14 AWG for continuous runs.
• When using multi-branch wire circuits with a shared neutral, do not operate any circuit with the neutral open. Also ensure all neutral
connections are secure before energizing the circuit. An open neutral can cause an overvoltage condition at the luminaire power supply.
To learn more about our products,
go to www.led.com
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
CAN ICES-005 (A) / NMB-005 (A).
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
To Next Page
Need help?
General
