GE Evolve User Manual

GE
Lighting
Evolve™ LED Area Light
Scalable Fixtures (EAS)
Troubleshooting
and Repair Guide
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation. This
Class [A] RFLD complies with the Canadian standard ICES-
003. Ce DEFR de la classe [ A ] est conforme à la NMB-003
du Canada.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required
to correct the interference at his own expense
• This luminaire is designed for outdoor lighting service, and
should not be used in areas of limited ventilation, or in high
ambient temperatures.
• Best results will be obtained if installed and maintained
according to the product’s installation instructions. Refer to
installation instructions if reinstalling after repair.
• Refer to product installation instructions and product
datasheet for specifications and installation details.
BEFORE YOU BEGIN
Read these instructions completely
and carefully. Save these instructions
for future use.
STOP
WARNING
!
Risk of electrical shock. Disconnect power before servicing
or installing product.
WARNING
!
Risk of injury or damage. Unit will fall if not installed properly.
Follow installation instructions.
CAUTION
!
Risk of injury. Wear safety glasses and gloves during
installation and servicing.

GE Evolve Specifications

General

Brand	GE
Model	Evolve
Category	Lantern
Language	English

Summary

Section 1: Light Engine(s) Out

Initial Checks and Power Disconnect

First steps for troubleshooting a light engine issue include visual checks and ensuring power is safely disconnected.

EASC Assembly Connection Checks

Checking leads and connectors in the EASC assembly for proper seating to diagnose light engine issues.

EASA/EASB Assembly Connection Checks

Checking leads and connectors in the EASA/EASB assembly for proper seating to diagnose light engine issues.

Driver Failure Identification

Identifying driver failure when all connections are secure but the light engine remains out, necessitating power door replacement.

Section 2: Day-Burning

Photocell Replacement for Day-Burning

Procedure to replace the photocell controller to resolve issues where the fixture fails to shut off at daybreak.

Photocell Receptacle Wiring Check

Inspect wiring at the photocell receptacle if photocell replacement does not resolve the day-burning problem.

Section 3: Power Door Replacement (EASC)

EASC Power Door Removal Procedure

Steps for safely disconnecting power and removing the EASC power door by releasing hinge pivots.

EASC Power Door Installation Procedure

Procedure for installing a new EASC power door, including verifying compatibility and securing connections.

Section 4: Power Door Replacement (EASA/EASB)

EASA/EASB Power Door Removal Procedure

Steps for safely disconnecting power and removing the EASA/EASB power door by separating disconnects and releasing hinge pivots.

EASA/EASB Power Door Installation Procedure

Procedure for installing a new EASA/EASB power door, including verifying compatibility and securing connections.