GE and the GE Monogram are trademarks of the General Electric Company. All other trademarks are the property
of their respective owners. Information provided is subject to change without notice. All values are design or typical
values when measured under laboratory conditions. GE Lighting and GE Lighting Solutions, LLC are businesses of
the General Electric Company. © 2015 GE.
15-0330 (Rev 10/15/15)
www.gelighting.com
Evolve™ LED Area Light
Scalable Fixtures (EAS)
Troubleshooting
and Repair Guide
Section 4: Power Door Replacement (EASA/EASB) (continued)
• To install new power door first verify that new power door is of the correct incoming voltage
and fixture wattage. Verify by checking name plate on right hand side of door.
• Reattach door in reverse order of removal.
• Verify that all leads are in the correct place after rewiring. Check against wiring sticker
located on top of drivers.
To Previous Page
Loading...
