GE Evolve - EASC Power Door Removal Procedure

To Next Page

To Previous Page

Evolve™ LED Area Light

Scalable Fixtures (EAS)

Troubleshooting

and Repair Guide

Section 3: Power Door Replacement (EASC) (continued)

• Cut and strip input leads to Light Engine disconnect at the connectors.

• Allow door to swing back and pivot and lift off of hinges

• To install new power door first verify that new power door is of the correct incoming voltage

and fixture wattage. Verify by checking name plate on right hand side of door against the

door just removed.

Hinge pivots

Other manuals for GE Evolve