MDS 05-4846A01, Rev. C SD Series Ref. Manual (Packet & Transparent Mode) 83
Invisible place holder
Figure 65. RTU Simulator Menu
Reprogramming the Transceiver
From time to time, GE MDS releases updated firmware for many of its
products, for the purpose of adding features or improving overall oper-
ation. You can benefit from these updates by downloading them from
www.gemds.com>>Resources>>Downloads and installing them in your
radio. Be sure to read any associated release notes before installing any
firmware to ensure that it is applicable to the model and configuration
you have.
The transceiver contains built-in tools to manage the reprogramming of
its firmware image(s). This section identifies the menu screens used in
reprogramming and directs you to more detailed procedures elsewhere
in this manual.
Local
Reprogramming
(via Serial or TFTP
Transfer)
Local reprogramming is performed by connecting a PC to the trans-
ceiver’s COM1 port (serial method) or Ethernet port (TFTP method).
The Local Reprogram Menu (Figure 66) is the starting point for both of
the reprogramming methods.
To Next Page
Loading...
