GE Monogram Installation Instructions

5
Installation
Automatic Icemaker
Remove
Packaging
and Parts
• Lay the carton on rear face and break open
the bottom flap.
•Set the carton upright with all four bottom
flaps outward.
•Lift carton up and off icemaker.
•Remove all tape and packaging material
from the outside and inside of the cabinet.
• Locate parts package with plastic plug
buttons. Set aside.
Adjust
Height of
Ice Machine
• Use a 1/4" socket to remove 7 screws from
the lower rear access panel. Carefully pull
the panel away from the drain hose.
To adjust the height:
• Use a 3/8" socket or Phillips screwdriver to
remove the nut on the wheel screw.
1. For cutout height of 34"
2. For cutout height of 34-1/8"
3. For cutout height of 34-5/16"
4. For cutout height of 34-1/2"
To adjust the front leveling legs:
• Use a spirit level to check level front to back
and side to side.
• With one person holding the ice machine at
the back side, carefully, tilt the machine
back to access the front leveling legs.
• Use an adjustable wrench to turn the legs.
– Turn legs right to lower, turn left to raise
the machine.
• Again, check top and side with a spirit level.
Continue adjusting legs until the ice
machine is level and stable.
Open Bottom Flaps
Remove Screws
Remove Screws
Height adjustments may be necessary to
install the ice machine below a countertop.
•Adjustable rear wheels are preset for a
cabinet opening height of 34".
• Use a 3/4” adjustable wrench to remove the
screw that holds the rear wheel.
• Move the rear wheel and screw to a new
position.
• Follow the same procedure on the opposite
side.
• Replace the rear panel with original screws.
Check to be sure the train tube is positioned
in the opening of the panel.
• Raise the front of the ice machine by
adjusting the front leveling legs.
Remove
Wheel
Screw
1
2
3
4
Raise
Lower

GE Monogram Specifications

General

Brand	GE
Model	Monogram
Category	Refrigerator
Language	English