GE Multilin 350 - Page 11

276
350 Feeder Protection System
Distribution Feeder Protection
• ModbusTCP/IP
• IEC60870-5-103
• IEC60870-5-104
These protocols make it easy to connect to
a Utility or Industrial automation system,
eliminating the need for external protocol
converter devices.
EnerVista
TM
Software
The EnerVista
TM
suite is an industry
leading set of software programs that
simplifies every aspect of using the 350
relay. The EnerVista suite provides all the
tools to monitor the status of the protected
asset, maintain the relay, and integrate
the information measured into DCS or
SCADA monitoring systems. Convenient
COMTRADE and sequence of event
viewers are an integral part of the 350 set
up software and are included to ensure
proper protection and system operation.
Simplified Feeder Setup
The 350 Feeder Protection System
includes a simplified setup process. This
simplified feeder setup consists of minimal
settings and can be accessed through
the relay front panel or via the EnerVista
Setup software. Once the information is
entered, the simplified setup will generate
a settings file, provide documentation
indicating which settings are enabled, and
an explanation of the parameters entered.
Viewpoint Monitoring
Viewpoint Monitoring is a simple to use
and full featured monitoring and data
recording software package for small
systems. Viewpoint monitoring provides a
complete HMI package with the following
functionality:
• Plugandplaydevicemonitoring
• Systemsinglelinemonitoringand
control
• Annunciatoralarmscreens
• Trendingreports
• Automaticeventretrieval
• Automaticwaveformretrieval
Display
A 4 line liquid crystal display (LCD) allows
visibility under varied lighting conditions.
When the keypad and display are not
being used, the metering summary page is
displayed to show critical metered values.
LEDs
The 350 relay has ten LED’s that provide
status indication for various conditions
of the relay and the system. The LED
indications are color coded to indicate the
type of event.
Fast and accurate configuration in one simple screen. 3 Series setup software protection summary for viewing a summary
of Protection & Control configuration.
Feeder protection settings in one easy step