GE MULTILINK ML2400 Quick Start Guide

QUICK START GUIDE
MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE QS–21
Z Select Run then enter CMD to start the DOS shell.
Once the DOS shell has launched, you will be presented with a DOS window.
Z At the DOS prompt enter the command ipconfig followed by the
Enter key.
This is the command that will cause the Ethernet adaptor to immediately use the IP, and
Subnet Mask addresses just programmed. An on-screen report will appear indicating
which addresses are now being used by the adapter. The computer’s configuration is
complete.
Addresses now being used

GE MULTILINK ML2400 Specifications

General

Brand	GE
Model	MULTILINK ML2400
Category	Switch
Language	English