QUICK START GUIDE
MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE QS–53
ML1600/2400# reboot
Proceed on rebooting the switch? [Y or N] Y
Rebooting now...
Z Login to the switch and use the show version command to verify
the version.
ML1600/2400# show version
Z If necessary, upload the configuration file using the following
commands.
If the current firmware is older than 1.7.3, use the loadconf
command as shown below:
Z If the current firmware is older than 1.7.3, enter the xmodem
command as shown below:
To Next Page
Loading...
