21
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
Problem Possible Causes What To Do
Dishes and flatware
Low inlet water • Make sure inlet water
not clean
temperature temperature is correct
(see page 11).
• Use
HI TEMP WASH.
Water pressure is • Turn on a faucet. Is water
temporarily low coming out more slowly
than usual? If so, wait until
pressure is normal before
using your dishwasher.
Air gap is clogged • Clean the air gap.
Improper rack loading • Make sure large dishware
does not block the
detergent dispenser or the
wash arms.
Spots and filming
• Use
Jet-Dry
®
rinse agent to
on glasses and
remove spots and prevent
flatware
new film build-up.
• To remove stubborn spots
and pre-existing film from
glassware:
1
Remove all metal utensils
from the dishwasher.
2
Do not add detergent.
3
Select the longest cycle.
4
Start the dishwasher and
allow to run for 18 to 22
minutes. Dishwasher will
now be in the main wash.
5
Open the door and pour
2 cups (500 ml) of white
vinegar into the bottom of
the dishwasher.
6
Close the door and allow
to complete the cycle.
If vinegar rinse doesn’t
work: Repeat as above,
except use 1/4 cup (60 ml)
of citric acid crystals
instead of vinegar.
Extremely hard water
Low inlet water
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
empty
Too little detergent
To Next Page
Loading...
Need help?
General
