.£
13
m
0
I,j
.£
.t..a
n
v A
vl rF*
Ill
.£
.i,,a
0
0
.z:
,zb
F_
v
.l..a
0
E
0
£J
Before you call for service...
Troubleshooting Tips
Possible Causes What To Do
Water filter indicator
light changed color
Water filter indicatorlight
remains red even after
replacing the water filter
This is normal.
Water filter indicator must
be reset.
• The water filter indicator light shows the following:
Green= Good
Orange = ChGngesoon
Red= ChGngeimmediGtely
• SeeAbout the water filter for more information.
Non-LCDmodels:
• Pressand hold the ICE& WATERpod for 3 seconds.
SeeAbout the water filter for more information.
LCDmodels:
• On the LCDscreen, select SETTING,then WATERFILTER.
Select REPLACEand follow the instructions given.
This is normal. This light will
turn orange to tell you that you
need to replace the filter soon.
The filter cartridge should be
.............................. replaced when the replacement
indicator light turns red.
• SeeAbout the water filter for more information.
Handle is looseI handle Handle needs adjusting. • SeeAttach theFreshFood handle and Attach
has a gap the Freezerhandle sections for detailed instructions.
This is the door alarm. • Closedoor.
Controlsetting is not lit
(non-LCDmodels)
On some models, the light
bulbs at the top of the refrigerator
compartment light up the
temperature control settings.
• Ifthe control settings do not light up, check to see if
the light bulbsare burned out, and replGceif necessary.
LCDscreen freezes
(LCDmodels)
LCD screen needs to be reset.
• Resetthe LCDscreen by inserting a paper clip into the
small hole next to the SDcard slot under the front edge
of the dispenseropening (seeScreen Functions:Photos
for location).
Notcooling. OF/OF
appears in the displag
The cooling system is off.
Non-LCDmodels:
• Pressand hold the ADJUSTFREEZERand ENERGVSAVER
padsatthe same time for 3 seconds.Youwill hear a beep
and the OF/OFwill disappear.You can now adjust the
temperature. Pleaseallow 24 hours for the unit to cool to
your set temperature.
Not cooling. OFF/OFF
appears in the displag
The cooling sgstem is off.
LCDmodels:
• On the LCDscreen,select SETTING,SYSTEMand then
COOLINGSYSTEMuntil a check mark appears beside
COOLINGSYSTEM.SelectHOME.Youcan now adjust the
temperature. Pleaseallow 24 hours for the unit to cool
to your set temperature.
42
To Next Page
Loading...
